|
Abstract:
A new diagnostic method
and system is put forward in this paper on the compensation motion
error. This new method transfers the motion error to the nermal
direction of out gear to be observed. Unlike the traditional method, the
new method does not need the reference system usually made up by
precision element, but uses a workpiece which has been cut by the
measured machine tool as a measurement element. According to the
principle of error correlation and error separation, compensation motion
error of machine tools and the waviness error of gear tooth can be
evaluated and the main errors can be found. Some examples are given at
the end of this paper.
Key words:
Gear
Machine tool Compensation Diagnosis
Received
19901211, received in revised form 19920402
|