|
Abstract: The differences of the bullet overload and the fuze overload are analyzed based on the study on the dynamic characteristics of bullet-fuze system, then the mathematic model of the bullet-fuze system transfer function is established. According to the demand of the system identifiability, the hammer test platform of bullet-fuze system is built, and the lectotype of the hammer is determined by the modal analysis of the finite element method. Using the test platform, output responses of bullet-fuze system excited by unit impulse under different tightening torque conditions are measured. The transfer function algorithm of bullet-fuze
system is presented based on the output error model of the system
identification, and the corresponding calculation program is compiled.
At last the transfer function is calculated, and output responses
calculated and measured results are compared in the same motivation
environment. The results show that the system identification algorithm of the bullet-fuze system transfer function and the output error model are credible, and the calculation accuracy is perfect.
Key words: Bullet-fuze system Transfer function System identification
CLC No:
TJ430.6
武器装备预研基金资助项目(5140C9384029389C475).
Received
20070921,
received
in
revised
form
20071224
|
| References
[1]
GAN Xuemei, HUANG Wenliang, HE Shaoping. In bore dynamic characteristics
study in projectile-fuze system[J]. Journal of
Ballistics, 1997, 9(6): 17-21.
[2]
MA Baohua. The structure and function of fuze [M]. Bei-jing: National
Defence Industry Press, 1984.
[3]
XI Zhanwen, ZHOU Tiansheng, CHENG Xiang. An investigation on the dynamic
characteristics of a projec-tile-fuze system close to the muzzle[J].
Acta Armamen-tarii, 1995, 2(5): 33-37.
[4]
JIANG Changzhen. The signal analysis and process[M]. Tianjing: Tianjin
University Press, 2000.
[5]
LI Guitao, SHANG Yaling, ZHAO Jianyu, et al. The virtual design technique
of warhead and fuze system[J]. Journal of Ballistics, 2001, 13(2): 7-13.
[6] JASON T G, SHUKLA A. Multiple impact penetration of semi-infinite
concrete[J]. International Journal of Impact
Engineering, 2001, 25: 965-979.
[7]
XING Jingzhong, WANG Yonggang, CHEN Xiaoxia. The analysis example and
engineering application of ANSYS 7.0[M]. Beijing: China Machine
Press, 2004.
[8] FORRESTAL M J, FREW D J. Penetration of concrete targets with
deceleration-time measurements [J]. Int. J. Impact Engng.,
2003, 28: 479-497.
[9]
LI Zhinong, HAO Wei, HAN Jie, et al. Factorial hidden Markov model
recognition method based on blind den-tification of nonlinear time
series models[J]. Chinese Journal of Mechanical
Engineering, 2007, 43(1): 191-195.
[10]
LIU Ning, WANG Taiyong, ZHAO Jian. Modal parameter identification using
wavelet transform method[J]. Journal of Tianjin
University, 2006, 39(7): 788-791.
|